Panasonic DMC-LS1GN - Manual (Page 47)

Recording pictures (basic)
47
VQT0Q78
• Hold down the shutter button fully to
activate the burst mode.
• When the self-timer is used, the number
of recordable pictures in burst mode is
fixed to 3.
• If the flash is activated, you can record
only 1 picture.
• When setting auto bracket and the burst
mode simultaneously, auto bracket will be
performed.
• The ways to control the exposure and the
white balance vary depending on the burst
mode setting. When the burst mode is set
to [
] or [ ], they are fixed to the
values set for the first picture. (The burst
speed is prioritised.) When the burst
speed is set to [
], they are adjusted
each time you take a picture.
• When setting the burst mode, the auto
review function is activated regardless of
the setting on the auto review function.
(The picture is not enlarged.) Moreover,
the settings for the auto review function on
the [SETUP] menu are disabled.
• Burst mode is not cancelled when the
camera is switched off.
• Burst mode will not perform as described
if a MultiMediaCard is used in place of an
SD Memory Card. The reading/writing
speed of a MultiMediaCard is slower than
that of an SD Memory Card.
VQT0Q78ENG.book 47 ページ ２００５年２月１４日 月曜日 午後１時１５分