Cd player, Cd playback – Philips AJ130/12 User Manual
Page 6

Autostore
Autostore automatically starts programming
radio stations from preset 1. Any previous
presets e.g. manually programmed will be
erased.
1
Press and hold PROGRAM/SET TIME until
the frequency in the display starts running.
➜ Available stations are programmed (FM).
After all stations are stored, the first auto-
store preset station will then automatically
play.
To listen to a preset or autostore
station
Press the PRE
3, 4 buttons once or more
until the desired preset station is displayed.
CD playback
•
This CD clock radio can play only audio discs
including CD-R (CD-recordable) and CD-RW
(CD-rewritable).
•
Do not try to play a MP3, CD-ROM,
CDI,VCD, DVD or computer CD.
1
Press POWER to switch on from standby.
➜ The system will switch to the last selected
source.
2
If CD is not selected, press SOURCE once
or more to select it.
➜
is displayed.
3
Lift the CD door to open.
4
Insert a CD with printed side facing up, and
close the CD door.
➜ ---- is displayed briefly, then total CD track
number.
5
Press
); to start playback.
6
To view CD track information, press
DISPLAY.
➜ The current track number is displayed for
several seconds (See 3), then it will
switch back to clock display.
7
To adjust the sound, turn VOLUME
3, 4.
8
To interrupt, press
);.To resume playback,
press
); again.
9
To stop playback, press
9.
Selecting a different track
•
Press
∞ /§ once or repeatedly until the
desired track number appears on the display.
•
In the stop position, press
); to start playback.
➜ The selected track number appears briefly
on the display when you press
∞ /§ to
skip tracks, then it switches back to clock
display.
Finding a passage within a track
1
During playback, press and hold down
∞ /§.
➜ The CD is played at high speed and low
volume.
2
Release
∞ /§ when you recognize the pas-
sage you want.
➜ Normal CD playback resumes.
Programming tracks
You may store up to 20 tracks in the desired
sequence for playback. If you like, store any
track more than once.
1
In the stop position, press PROGRAM/SET
TIME to enter programming mode.
➜ PROG and P
P0
01
1 are displayed, flashing,
indicating the start of programming
(See 4).
2
Press
∞ /§ to select desired track.
3
Press PROGRAM/SET TIME to store the
track.
➜P
P0
02
2 is displayed, flashing, indicating the
second program sequence is available.
4
Repeat steps 2 to 3 to select and store all
desired tracks.
➜ If you attempt to store more than 20
tracks, no tracks can be stored.
5
Press
); to play the program.
➜ PROG is displayed.
To review a program,
In the stop position, press and hold
PROGRAM/SET TIME until all the stored
tracks are displayed.
CD Player
AZ130-ENG 2010.5.6 11:38 Page 6