Philips 19PFL4322 - Manual (Page 17)

10
TV menu-Setup
Select Autoprogram in the Setup menu.
Use the cursor right to enter the Autoprogram menu.
Select Auto, Cable or Antenna in the Setup mode.
Select Start now with the cursor right key.
Press the OK button.
Make sure that registration with your cable TV provider and
connection of equipment are completed.
Auto programming may take up to 2 minutes to complete. Please
wait until you see the Auto Programming complete message. The
TV will then switch automatically to the fi rst channel found.
Note: All channels must be unlocked in order to autoprogram. If
requested, Access code to unlock all channels. (p. 20)
Info
Setup Language 6 4
Français
Español
Português
English Language
Autoprogram
Source
Channel edit
Clock
Reset AV settings
Info
Setup Autoprogram 6 3
Antenna
Cable
Auto Language
Channel edit
Source
Clock
Reset AV settings
Autoprogram
Info
Autoprogram 3
Auto
Auto
Antenna Start now
Cable
Auto
Please wait
Prog. found 0
Notes:
• When you have locked TV channels before initiating Autoprogram, a message appears asking to Access code in
order to complete Autoprogramming.
• When channel update is interrupted, the new updated channel information is retained. The old un-updated
channel information is erased.
• Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory.
• If Antenna/cable signal is interrupted more than thirty minutes, TV will go into off mode. You are requested to press
Power button or CH + / - button to turn on the TV.
Select the menu language
Press the MENU button on the remote control.
Use the cursor down to select Setup in the Settings menu.
Use the cursor right to enter the Setup menu.
Select
Language and enter the list of available languages with the
cursor right.
Select your preferred language with the cursor up/down and press
the
OK button to confi rm your selection.
Proceed with the Setup menu.
Store TV channels
1
2
3
4
5
6
1
2
3
4
5