Basic operation, Power on/off, Select viewing source – Palsonic PDP 4280HD User Manual

Page 9

Basic Operation

Power On/Off

Please use the direction buttons to select desired signal, and press "OK" or " " button to confirm.

Note:

Please make sure the connection for your choice is available.

For example, "TV" for watching TV, "VGA" for PC .If the TV can't find any signal input, you can

try to press ''POWER'' button on remote control or the on the panel to restart the TV.

Connect the TV unit to power source using power cord.

When the power indicator in red, the TV is in standby mode. Now press the "POWER" button on remote

control or front panel to turn on the TV. The TV works normally when the power indicator is in green.

Switch the TV to standby mode, just press "POWER" button on the remote control or front panel.

Now the indicator will be in red.

The power consumption is less than 1W in standby mode. If unused for a long time, please

disconnect the power cord from the wall outlet.

Note: The TV set can turn off automatically after 5 minutes while there has no signal input.

Select Viewing Source

Press the "SOURCE" button to display the sources list.

Input Source

DTV

AV2

AV3

Component

Component 2

PC RGB

HDMI 1

HDMI 2

EXIT