Premier Mounts WMK-027 - Manual (Page 5)

Installation Instructions Page 5
Wood Stud Installation
DEAD CENTER MUST BE LOCATED ON THE STUD FOR CORRECT AND SAFE INSTALLATION.
Step 1. Use an electronic stud finder
(commercially available) to
locate the center of the stud
that is in the wall.
Step 2. Use a pencil to mark the first
mounting hole, just above
your height mark (from
page 4).
Step 3. Use the level to make sure
the wall plate is level from
top to bottom. After
determining the desired
viewing height, place the
wall plate over the first hole
and use a pencil to mark the
rest of the holes.
Wood Stud
Stud finder
Marking
(from page 4)
Wood Stud
Marking
Wall
Plate
Do NOT over-tighten lag bolts when attaching the mount to the wall. Improper installation may result in personal injury
or damage to property.
WMK-027
Step 4. Once the holes have been
marked, use a 1/4” drill bit
and portable drill to drill the
pilot holes.
Step 5. After the pilot holes have
been drilled, use four (4)
5/16” x 3” lag bolts and four
(4) flat washers to mount the
wall plate to the wooden
stud. Use a 1/2” socket and
socket wrench to finish this
step.
Step 6. Insert and gently tap the wall
plate covers into place.
Drill
Marking
Socket
Lag Bolt and
Flat Washer
Wall
Plate
Completed Installation
Wall Plate
Covers