Premier Mounts Clevis Mount CTM-MS3 - Manual (Page 13)

CTM-MS3
Installation Manual Page - 13 -
Step 2. Make any lateral shift adjustment and lock it by tightening the two (2) M6 x 30mm Phillips screws found on the bottom of
the mounting brackets. Use the foot leveler to adjust your plasma.
Do not over tighten the M6 x 30mm screws to the rods.
To remove the display from the wall simply back off the M6 x 30mm screws using a Phillips screwdriver and lift
the unit of the wall carefully.
Wall Plate
Lateral Shift