Control variables (dcc cv), 0, speed from dcc – PMI - Phoenix BIGSOUND P5 User Manual
Page 10
Control Variables (DCC CV)
Versions of the P5 firmware after 1.00 support the following Control
Variables. These can be programmed on the program track or using
service mode programming.
OPS
MODE
IS
NOT
CURRENTLY
SUPPORTED
.
CV Description
Default Value
1 Short Address
3
17 Long Address
0
18 Long Address
3
49 0 = Speed from Triggers;
≠ 0, speed from
DCC
0
50 The DCC Value where motion starts.
2
51 The DCC Rate (Speed vs. Throttle)
100
52 Seconds to simulate DCC if DCC signal is lost.
0 = Forever
0
53 Seconds in idle before shutdown.
0 = Never shutdown
0
February 2009
- 10 -