Pioneer PureVision PDP 42A3HD - Manual (Page 22)

06 Basic Operations
22
En
4 Select PIP/TWIN Mode and press the \ or OK button
again.
5 Press the c or d button to select the required option as
follows, then press the [ or the BACK button.
Off - PIP - TWIN1 - TWIN2
Off
PIP
TWIN1
TWIN2
PIP/TWIN
PIP/TWIN Mode PIP
PIP/TWIN Input DIGITAL CH
PIP Position
Move Enter Return
• If you set to Off, the following steps are not available.
6 Press the c or d button to move to PIP/TWIN Input,
then press the \ or OK button.
7 Press the c or d button to select the required input
source as follows, then press [ or the BACK button.
DIGITAL CH - ANALOG CH - VIDEO 1 - VIDEO 2 -
VIDEO 3 - S-VIDEO 1 - S-VIDEO 2 - S-VIDEO 3 -
COMPONENT 1 - COMPONENT 2 - HDMI
PIP/TWIN
PIP/TWIN Mode PIP
PIP/TWIN Input DIGITAL CH
PIP Position
DIGITAL CH
ANALOG CH
VIDEO 1
VIDEO 2
VIDEO 3
S-VIDEO 1
S-VIDEO 2
S-VIDEO 3
COMPONENT 1
COMOPNENT 2
HDMI
Move Enter Cancel
• You can select the modes by simply pressing the SPLIT button
on the remote control.
• You can select the sources by simply pressing the SPLIT
INPUT button on the remote control.
• In Twin or PIP mode, press the SWAP button to switch the
position of the 2- screen shown.
If you select “PIP” in the step 5
You can select the position of picture in picture display.
Press the c or d button to move to PIP Position, then press
the \ or OK button.
PIP/TWIN
PIP/TWIN Mode PIP
PIP/TWIN Input DIGITAL CH
PIP Position
Move Enter Return
• You can select the positions by simply pressing the SHIFT
button on the remote control.
8 Press the c or d button to select the required position
for the sub-picture, then press the [ or BACK button.
9 Press the EXIT button.
• You can turn off the sub-picture by simply pressing the EXIT
button on the remote control.
• Multi screen function is available with the following combina-
tions:
DIGITAL CH - ANALOG CH
DIGITAL CH/ANALOG CH - VIDEO1/2/3, S-VIDEO1/2/3,
COMPONENT1/2 or HDMI
(Upper left) (Upper right)
(Bottom left) (Bottom right)
07-PDP42A3HD-Eng (18-22) 5/17/05, 7:28 PM 22