Philips CDR951 - Manual (Page 3)

English
11
For recording the following inputs are present:
- Digital optical input.
- Digital coaxial input 1.
- Digital coaxial input 2.
- Analog input.
For playback the following outputs are present:
- Digital coaxial output.
- Digital optical output.
- Analog output.
We advise you to connect these to the CD input on your
amplifier.
The connections you make will depend upon the possibilities
your audio equipment offers. Please refer to the user manuals
for your other audio equipment first.
Digital recordings (optical or coaxial) give the best
performance in audio and usability (e.g. auto-track).
(The digital optical connection is less sensitive to external
disturbances).
If your equipment does not offer digital connections, the high
quality Analog-Digital-Convertor of your CD recorder will
ensure very good audio performance when recordings are
made from the analog input.
Playback via the digital coaxial output of the CD recorder
gives the best audio performance.
If your equipment does not offer digital connections, the high
quality Digital-Analog-Convertor of the CD recorder ensures a
very good sound quality via the analog output.
We advise you to always establish both digital and analog
connections. In this way you can always make analog
recordings when digital recording is not possible.
We have described the most common ways of connecting the
CD recorder. If you still have difficulties with the connections
you can always contact the Philips Consumer Service desk in
your country.
Analog connection is required for playback of CDs (use cable
2) and for recording from external analog sources
(use cable 1).
Use the audio cables supplied. Connect the red plugs to the
R sockets, and the white plugs to the L sockets.
1 For recording, connect cable 1 between the ANALOG IN-
sockets on the CD recorder and the CDR LINE- or TAPE OUT-
sockets of an amplifier.
Note: For recording directly from a CD player, the ANALOG IN
sockets of the CD recorder should be connected to the
analog output of the CD player.
2 For playback, connect cable 2 between the ANALOG OUT-
sockets on the CD recorder and the input sockets of an
amplifier e.g. TAPE IN, CDR or AUX.
Note: Never use the PHONO input.
OPTICAL
IN
OUT
DIGITAL
IN1
IN2
OUT
ANALOG
L
R
L
R
IN OUT
CD RECORDER
RECEIVER
TAPE
L
R
L
R
IN OUT
1
2
Analog connections Connections general
INSTALLATION