beautypg.com

Service and adjustments – Poulan 195806 User Manual

Page 24

background image

24

0066

3sq

RE TAIN ING
RING

WASH ERS

FIG. 28

AXLE
COVER

TO REMOVE WHEEL FOR REPAIRS

FRONT WHEEL (See Fig. 28)
• Block up axle securely.
• Remove axle cover, retaining ring and washers to allow

wheel removal.

• Repair tire and reassemble.
• Replace washers and snap retaining ring securely in

axle groove.

• Replace axle cover.

REAR WHEEL -
• Block rear axle securely.
• Remove fi ve (5) hub bolts to allow wheel removal.
• Repair tire and reassemble. Replace and tighten hub

bolts securely.

NOTE: To seal tire punctures and prevent fl at tires due to
slow leaks, tire sealant may be purchased from your local
parts dealer. Tire sealant also prevents tire dry rot and
corrosion.

SERVICE AND ADJUSTMENTS

02614

WEAK OR DEAD
BATTERY

FULLY CHARGED
BATTERY

FIG. 29

TO START ENGINE WITH A WEAK BAT TERY
(See Fig. 29)

WARNING: Lead-acid batteries gen-
er ate ex plo sive gases. Keep sparks,
fl ame and smoking ma te ri als away from
bat ter ies. Always wear eye pro tec tion
when around batteries.

If your battery is too weak to start the engine, it should be
recharged. (See "BATTERY" in the Maintenance sec tion
of this man u al).

If “jumper ca bles” are used for emer gen cy starting, follow
this pro ce dure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT
SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT
SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START
OTHER VEHICLES.

TO ATTACH JUMPER CABLES -
• Connect one end of the RED cable to the POSITIVE

(+) terminal of each battery(A-B), taking care not to
short against tractor chassis.

• Connect one end of the BLACK ca ble to the NEGA TIVE

(-) terminal (C) of fully charged battery.

• Connect the other end of the BLACK cable (D) to good

chassis ground, away from fuel tank and bat tery.

TO REMOVE CABLES, REVERSE ORDER -
• BLACK cable fi rst from chassis and then from the fully

charged battery.

• RED cable last from both batteries.

TO AD

JUST STEER

ING WHEEL ALIGN-

MENT

If steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straight forward, remove steer-
ing wheel and reassemble per instructions in the Assembly
section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on
your tractor. If damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center/department.