Peavey XR 8600 - Manual (Page 15)

1
XR ® 8300 & XR ® 8600 Specifications
Function
Input Z
(ohms)
Min
Input Gain
Control
Settings Min** Nominal* Max
Bal
Unbal
Connector
Lo-Z Mic
(150 ohms)
2k Max w/o
pad (50dB)
Max w/pad
(25dB)
-59dBu
-34dBu -29dBu
-4dBu
-11dBu
+14dBu
Bal XLR Pin 1 Gnd
Pin 2 (+)
Pin 3 (-)
Line Input 22k Max w/o
pad (30dB)
Max w/pad
(25dB)
-27dBu
-2dBu
+2dBu
+27dBu
+21dBu
+26dBu
Bal 1/4" TRS;
Tip (+)
Ring (-)
Sleeve Gnd
Tape 20k Max Gain
(30dB)
-26dBu +4dBu +21dBu Unbal RCA jacks
Input Specifications
Features and specifications subject to change without notice.
Input Levels
0dBU = 0.775V (RMS)
** Minimum input level (sensitivity) is the smallest signal that will produce nominal output (4dBu)with channel and master controls set for
maximum gain.
* Nominal settings are defined as all controls set at 0dB (or 50% rotation for rotary pots).
Output Specifications
Function minimum Load Z
(ohms)
Nominal Max Bal
Unbal
Connector
Main 600 +4dBu +21dBu Unbal 1/4" Phono Tip (+)
Sleeve Ground
Monitor 600 +4dBu +21dBu Unbal 1/4" Tip (+)
Sleeve Ground
Tape 10k -10dBu +10dBu Unbal RCA
+4dBu = 1.23V (RMS)
Gain:
Mic Input to Main Output
Line Input to Main Output
60dB (Max Gain)
30dB (Max Gain)
Frequency Response:
Mic Input to Main Output
Line Input to Main Output
To Power Amplifier Output
20Hz-20kHz +0dB/-1dB
20Hz-20kHz +0dB/-1dB
40Hz-20kHz +0dB/-1dB
Total Harmonic Distortion:
Graphic Equalizer:
Filter Frequencies
Maximum Boost and Cut
80, 250, 500, 1k, 2k, 4k, 10k
+12dB Boost, -12dB Cut
<0.01% 20Hz-20kHz Mic Input to Main/Monitor Output at Nominal Level (20Hz-80kHz BW)
<0.01% 20Hz-20kHz Line Input to Main/Monitor Output at Nominal Level (20Hz-80kHz BW)
<0.005% Typical @ 1kHz