Peavey XR 8600 - Manual (Page 14)

1 14
Rear Panel
AC POWER INLET:
This is the receptacle for an IEC line cord, which
provides AC power to the unit. Connect the line
cord to this connector to provide power to the unit.
Damage to the equipment may result if improper
line voltage is used. (See line voltage marking on
unit).
Never break off the ground pin on any equipment.
It is provided for your safety. If the outlet used
does not have a ground pin, a suitable grounding
adapter should be used and the third wire should be grounded properly. To prevent the risk of shock or
fire hazard, always make sure that the amplifier and all associated equipment is properly grounded.
NOTE: FOR UK ONLY
As the colours of the wires in the mains lead of this apparatus may not correspond directly with the col-
ored markings identifying the terminals in your plug, proceed as follows: (1) The green and yellow wire
must be connected to terminal which is marked with the letter E, or by the earth symbol, or is coloured
green, or green and yellow. (2) The blue wire must be connected to the terminal which is marked with
the letter N, or the colour black. (3) The brown wire must be connected to the terminal which is marked
with the letter L, or the colour red.
To avoid the risk of electrical shock, do not place fingers or any other objects into empty tube sockets
while power is being supplied to unit.
FUSE
This is the main safety fuse for the AC line voltage. Only replace with a fuse of the exact type and rating.
If the fuse continues to open‚ take the unit to an authorized Peavey service center.
POWER SWITCH
This is the main power switch. The power on LED indicator on the front of the unit will illuminate when
the unit is powered.
MAIN/MONITOR AND MAIN OUTPUTS
These combination jacks (1/4" or Speakon®)
are the amplifier’s outputs.
35
36
37
37 35 36
38
38