Pride Mobility Mini Crosser - Manual (Page 27)

27 Mini Crosser www.pridemobility.com
V I I . C O M F O R T A D J U S T M E N T S
SEAT HEIGHT ADJUSTMENT
You can change the seat height by adjusting the upper seat post up or down.
1. Turn the PMV off and place the manual freewheel lever in drive mode.
2. Lift the seat up and off of the seat post.
3. Remove the shroud release screw. See figure 16.
4. Pull the shroud towards the tiller then lift up to remove it. See figure 17.
5. Loosen the seat height adjustment bolts. See figure 18.
6. Slide the upper seat post up or down in the lower seat post.
WARNING! Do not extend the upper seat post from the lower seat post farther then the
HORIZONTAL groove that is marked on the upper seat post.
7. Tighten the seat height adjustment bolts.
8. Reinstall the shroud and tighten the shroud release screw.
9. Reinstall the seat.
Figure 17. Rear Shroud Removal Figure 16. Shroud Release Screw
SHROUD RELEASE SCREW
Figure 18. Seat Height Adjustment
SEAT HEIGHT
ADJUSTMENT
BOLTS
LOWER SEAT POST
UPPER SEAT POST