Philips AJ3290 - Manual (Page 6)

ALARM/SLUMBER ADDITIONAL INFORMATION
You can switch off the alarm in three ways:
Unless you choose to cancel the alarm
completely, the ALARM RESET option will be
automatically selected after 59 minutes from the
time your alarm first goes off.
Alarm reset
If you want the alarm mode to be stopped
immediately, but also wish to repeat the alarm
call at the same time for the following day:
• Press ALARM RESET during the alarm call.
Repeat alarm
This will repeat your alarm call at 7 minutes
intervals.
• Press
SLUMBER OFF /REPEAT ALARM.
• Press SLUMBER OFF /REPEAT ALARM again
during the next call if you wish to repeat the
alarm call.
• If, however, you do not press SLUMBER
OFF /REPEAT ALARM again, the alarm will
sound for 59 minutes before turning itself off.
Your alarm time setting will then
automatically enter the ALARM RESET mode
to sound at the same time next day.
Cancelling the alarm completely
• Before or during the set alarm goes off, push
the AL (1 or 2) switch to the OFF position.
– The alarm indicator will disappear from the
display.
About SLUMBER time
The clock radio has a built-in timer device called
the SLUMBER, which enables the radio to be
automatically switched off after a set period of
time; this allows you to lie back, listen and fall
asleep. The maximum slumber time is 59
minutes.
Setting and switching off SLUMBER
1. Set the RADIO switch to the OFF position.
2. Set your slumber time by pressing on the
SLUMBER button. Keep your finger on the
button and the display will begin to count
down from 59 to 00 minutes.
3. Release the button as soon as the required
slumber time is reached.
4. To cancel the SLUMBER function, press
SLUMBER OFF /REPEAT ALARM.
Notes:
– The slumber function does not affect the
alarm setting(s).
– If during SLUMBER you have turned down the
volume and you have an alarm set in radio
mode, make sure you have adjusted the
volume loud enough to wake you up the next
day.
– If you do not intend to use the clock radio for
a long time, disconnect the set by removing
the plug from the wall socket. The battery
should also be removed to prevent chemical
leakage which will damage your set.
– To clean your set from fingerprints, dust and
dirt, use a clean and soft damp cloth or
chamois leather. Do not use cleaning products
which contain benzene, thinner etc. as these
may harm the housing.
MAINTENANCE
SLUMBER SWITCHING OFF THE ALARM
6
English
AJ3290/00 page 6
XP AJ 3290/00.1 22-06-2000 12:12 Pagina 6