Philips AJ3290 - Manual (Page 5)

CLOCK RADIO ALARM
Clock display
The time is displayed using the 24-hour clock
system.
1. Adjust the clock control to the TIME SET
position.
2. Press and hold down the 7 or 4 buttons to
set and adjust both the hours and the minutes.
– With your finger held down on
7, the time
will increase rapidly and continuously from
minutes to hours.
– With your finger held down on 4, the time
will slowly count down minute by minute.
3. Release the 8 or 4 buttons when you have
reached the correct setting.
4. To safeguard the clock time from being
accidentally adjusted, turn the clock control to
the RUN position.
You can use this clock solely as a radio.
1. Set the RAD switch to ON.
2. Select your wave band using the BAND
switch.
3. Tune to desired radio station using the
TUNING knob.
4. Set the volume by turning the VOLUME control.
5. To turn off the radio, set the RAD switch to
OFF.
To improve radio reception
– For AM, (MW or LW ) the set is provided with
a built-in aerial which to function best should
be placed on a non-metallic surface e.g.
wood, plastic. Direct the MW aerial by
adjusting the position of your clock radio.
– For FM , extend the pigtail wire at the back of
the set completely for optimum reception.
General
If you wish to use the alarm, then you should
first set the alarm time. There is also the choice
of two modes for waking you up: by buzzer or
radio. The display will show the alarm indicator
in the bottom left or right corners if the alarm is
set.
1. Adjust the clock control to the ALARM 1 or 2
position.
2. Press and hold down the
7 or 4 buttons to
set and adjust both the hours and the minutes.
– With your finger held down on
7, the time
will increase rapidly and continuously from
minutes to hours.
– With your finger held down on 4, the time
will slowly count down minute by minute.
3. Release the 7 or 4 buttons when you have
reached the correct setting.
4. Adjust the clock control to the RUN position to
return to clock time display.
– To review your set alarm time, adjust the
clock control to the respective ALARM 1 or
2 position.
5. To select the alarm mode you wish to be
awoken by, set the respective AL 1 or 2
switch to
RAD or BUZ .
– If you have selected the radio mode, make
sure you have adjusted the volume loud
enough to wake you.
– The 2 buzzers are at a set volume and
cannot be adjusted. BUZ on AL 1 is a low
tone buzzer while BUZ on AL 2 is a high
tone.
SETTING THE ALARM
RADIO
SETTING THE CLOCK
5
English
AJ3290/00 page 5
XP AJ 3290/00.1 22-06-2000 12:12 Pagina 5