Panasonic EY6506 - Manual (Page 6)

- 6 -
.ASSEMBLY ASSEMBLY
Attaching or removing bit Attaching or removing bit
NOTE:
When attaching or removing a bit,
disconnect battery pack from tool or
place the switch in the center posi-
tion (switch lock).
1. Hold the collar of quick connect chuck
and pull it against the driver.
2. Insert the bit into the chuck.
3. The bit holder will return to its original
position when it is released.
4. Pull the bit to make sure it does not
come out.
5. To remove the bit, pull back on the bit
holder in the same way.
CAUTION:
If the bit holder does not return to its
original position or the bit comes out
when pulled on, the bit has not been
properly attached. Make sure the bit
is properly attached before use.
Attaching or removing Attaching or removing
battery pack
battery pack
1. To connect the battery pack:
Insert the battery pack. It snaps into
place to indicate proper connection.
2. To remove the battery pack:
Press the two buttons on the sides
of the battery pack. Slide the battery
pack out of the tool body.
.OPERATION .OPERATION
Switch and Forward Switch and Forward / Reverse Reverse
lever Operation lever Operation
(Forward ( ), Switch lock, Reverse ( ))
CAUTION:
Do not operate Forward/Reverse
lever until the bit comes to a com-
plete stop.
Forward Rotation Switch Forward Rotation Switch
Operation
Operation
1. Push the lever for forward rotation.
2. Depress the trigger switch slightly to
start the tool slowly.
3. The speed increases with the amount
of depression of the trigger for efficient
tightening of screws. The brake oper-
ates and the bit stops immediately
when the trigger is released.
4. After use, set the lever to its center po-
sition (switch lock).
Reverse Rotation Switch Reverse Rotation Switch
Operation
Operation
1. Push the lever for reverse rotation. Check
the direction of rotation before use.
2. Depress the trigger switch slightly to
start the tool slowly.
3. After use, set the lever to its center po-
sition (switch lock).
CAUTION CAUTION
To eliminate excessive tempera ture
increase of the tool surface, do not oper-
ate the tool continu ously using two or
more battery packs. Tool needs cool off
time before switching to another pack.
For Appropriate use of For Appropriate use of
Battery pack
Battery pack
Ni-MH Battery pack (EY9200)
Charge the Ni-MH battery fully before
storage in order to ensure a longer
service life.
The ambient temperature range is be-
tween 0°C (32°F) and 40°C (104°F).
If the battery pack is used when the
battery temperature is below 0°C
(32°F), the tool may fail to function
properly. In that case, charge the
battery until charging is completed for
appropriate functioning of the battery.
When battery pack is not in use, keep it
away from other metal objects like: paper
clips, coins, keys, nails, screws, or other
small metal objects that can make a con-
nection from one terminal to another.
Shorting the battery terminals together
may cause sparks, burns or a fire.