beautypg.com

Wire identification – Philips Signal Mirror CRV 1997-2003 User Manual

Page 13

background image

6

16

3

Wire Identification

15. Repeat all of the previous steps to replace the factory mirror on the passenger side door with the new Signal

®

mirror. The vehicle's electrical wiring

is located underneath the dash behind the fuse block assembly. Guide the new wire harnesses from both sides of the vehicle to the electrical wiring.
Locate the GREEN WITH RED STRIPE and SINGLE GRAY RINGED wire from within the wire bundle. Turn the ignition key so that electrical
power is on and activate the driver side turn indicator. Probe the wire with the wire tester to verify that flashing turn indicator power is present.
Label that wire as ‘driver side turn’.


16. Locate the GREEN WITH YELLOW STRIPE and SINGLE GRAY RINGED wire from within the wire bundle. NOTE: There are two or more

wires with the same color pattern. Activate the passenger side turn indicator and probe the wire with the wire tester to verify that flashing turn
indicator power is present. Label that wire as ‘passenger side turn’.

1997-2003 Honda CRV