Philips 9160XL - Manual (Page 8)

ENGLISH 15 ENGLISH 14
Placing or removing razor from
charging stand:
C
◗ Always place razor in stand in an upright
position making sure charging contacts in
bottom of stand fit into recess in bottom of
razor.
C
◗ Always remove razor from stand by lifting
straight up. Do not tilt razor.
◗ Do not leave the charging stand with the
razor in it continuously plugged into outlet as
it would reduce life of batteries. If storing
razor in stand, remove the plug from outlet as
soon as the razor is fully charged.
C
1 Connect cord directly to razor or place
razor in charging stand and connect the
small plug of cord to charging stand.
Connect the charging plug into any 100V
to 240V AC outlet. Use only the charging
plug provided.
As you charge razor, the bottom light on the
display turns red. After approximately 3 minutes,
it will then turn green and blink. As charging
continues, more and more lights of the display
meter will briefly blink green and light up to
indicate what level of the batteries have been
charged.
◗ An adaptor plug may be necessary for
charging plug usage in some foreign countries.
Use an attachment plug adaptor of the proper
configuration for the power outlet.
The charging plug will automatically convert to
work on 100V to 240V AC systems.
2 First time charging and recharging after
non-use for 1 month or more requires a
full 4 hours. A fully charged razor has a
cordless shaving time of up to 30 days.
When batteries are fully charged, all the “lights” in
the display will light up green. A few hours after
charging, all lights go off.
Recharging
1 First time charging requires 4 hours. After
initial charge, recharging requires 1 hour.
Recharge only when the bottom light on the
display lights up red.
C
2 When razor is fully charged, disconnect
the charging plug from outlet.
Do not keep razor or charging stand permanently
plugged into outlet. If using charging stand, always
remove razor from stand by lifting straight up. Do
not tilt razor.