Philips 9160XL - Manual (Page 7)

Before First Use
◗ Charge the razor before you start using it
(see ‘Charging’). Make sure the razor is
switched off before you start charging it.
Important
◗ Only use the power plug and/or charging
stand provided to charge the razor.
◗ The charging plug transforms 100 – 240V AC
to less than 24V DC.
Charging
◗ Battery performance is best if you recharge
only when the batteries are (almost)
completely empty.
◗ Charging or recharging at temperatures below
40ºF or higher than 95ºF adversely affects
lifetime of batteries.
◗ Continuously recharging or continuously using
as a corded razor will reduce life of batteries.
◗ You may also shave using the cord provided.
This razor will not recharge while being used
corded.
◗ Do not charge razor in a pouch.
◗ Recharge only when the bottom light on the
display lights up red.
◗ Do not charge/recharge or use razor corded
until fully dried.
ENGLISH 13 ENGLISH 12
To replace clock battery
C
1 Turn clock module counterclockwise (1)
and remove from stand (2).
C
2 Remove battery cover and then use a flat-
bladed screwdriver to lift out the battery.
C
3 Replace battery with 1.5V button cell
watch battery, placing rounded side of
battery into battery compartment, flat side
(+) facing out. Replace battery cover.
C
4 Replace clock module into stand (1) and
turn clockwise to secure in place (2).
1
2
1 2