PYLE Audio PLDVD168 - Manual (Page 24)

TROUBLE SHOOTING
Before going through the check list, check wiring connection. If any of the problems
persist after check list has been made, consult your nearest service dealer.
Symptom Cause Solution
No power. The car ignition switch is If the power supply is properly
not on. connected to the car accessory
terminal, switch the ignition key
to “ACC“.
The fuse is blown. Replace the fuse.
Disc cannot be Presence of disc inside the Remove the disc in the player,
oaded or player Then put a new one
ejected.
Inserting the disc in reverse Insert the compact disc with
direction. the label facing upward.
The disc is extremely dirty or Clean the disc or try to play a
defective new one.
Temperature inside the car Cool off or until the ambient
is too high. temperature return to normal.
Condensation. Leave the player off for an hour
then try again.
No sound. Volume is in minimum. Adjust volume to a desired level.
Wiring is not properly Check wiring connection.
connected.
Sound skips. The installation angle is Adjust the installation angle less
more than 30 degrees. than 30 degrees.
The disc is extremely dirty Clean the compact disc, then
or defective disc. try to play a new one.
The operation The built-in microcomputer Press the RESET button.
keys do not is not operating properly Front panel is not properly
work. due to noise. fixed into its place.
The radio does The antenna cable is not Insert the antenna cable firmly.
notwork. connected.
The signals are too weak. Select a station manually.
This product incorporates copyright protection technology that is protected by method
claims of certain U.S. patents and other intellectual property rights owned by
Macrovision Corporation and other rights owners.Use of this copyright protection
technology must be authorized by Macrovision Corporation, and is intended for home
and other limited viewing uses only unless otherwise authorized by Macrovision
Corporation. Reverse engineering or disassembly is prohibited.
www.pyleaudio.com
88-V2490-02