Unloading the stack, Loading the stack, Initializing the stack – Philips ISP1362 User Manual
Page 20
Philips Semiconductors
ISP1362 Linux Stack User’s Guide
UM10012-_2
© Koninklijke Philips Electronics N.V. 2003. All rights reserved.
User’s Guide
Rev. 1.2—July 2003
20 of 34
You should also see the
msdisk
application running as an application process when you list the current
running processes (
ps
).
4.1.2.
Unloading the Stack
1. As root of the system, go to the ISP1362 Linux source directory and use the script to unload module.
#cd /usr/src/linux-otg/1362/source/objs
#./rmod
2. If you execute the
/sbin/lsmod
command, you should not see any of the following modules as loaded:
mscd, pdc, phci, otg, hal
Also, you should not see the
msdisk
application as a running process when you list the current running
processes (
ps
).
4.2.
ISP1362 Add-on Card for Intel PXA250 based Accelent IDP (Rev 04)
4.2.1.
Loading the Stack
The ISP1362 Linux stack modules (kernel as well as application) are dynamically loaded and unloaded to the
kernel.
1. Log on to the system as root, go to the ISP1362 object directory and use the script to load modules..
#cd /home/1362/objs
#./imod
2. If you execute the
/sbin/lsmod
command, you will notice that the following modules are loaded:
mscd, pdc, phci, otg, hal
You should also see the
msdisk
application running as an application process when you list the current
running processes (
ps
).
4.2.2.
Unloading the Stack
1. As root of the system, go to the ISP1362 Linux object directory and use the script to unload module.
#cd /home/1362/objs
#./rmod
2. If you execute the
/sbin/lsmod
command, you should not see any of the following modules as loaded:
mscd, pdc, phci, otg, hal
Also, you should not see the
msdisk
application as a running process when you list the current running
processes (
ps
).
4.3.
ISP1362 Add-on Card for Intel PXA250 based Accelent IDP (Rev 02)
4.3.1.
Initializing the Stack
After booting the Accelent IDP needs some initial setup for the ISP1362 stack to run. The initialization is done by
executing the initialization script.
#cd /home/1362/objs
#./init_stack