beautypg.com

Connecting the loudspeakers, Piega ap 3, as 3 – Piega AP 3 User Manual

Page 9

background image

Connecting the Loudspeakers

PIEGA AP 3, AS 3

Instructions for connecting the loudspeakers...

9

The loudspeaker is provided with the terminal for single wiring applications. This is used for connecting standard loudspeaker cables

with banana plugs. Ideally however, PIEGA AP3, AS 3 loudspeakers are connected with the OPUS 3 loudspeaker cable which was

specially developed for PIEGA loudspeakers with ribbon tweeters, and is available as an accessory from specialist dealers.

Connection:

>Ensure that the electronic components are switched off before making

the connection

>The AP 3, AS 3 loudspeakers must only be connected to electronic

components with the amplifier outputs recommended by PIEGA

>Ensure without fail the recommended amplifier output of 20 - 200 W

(4 Ohm) - If you are not sure that the connection is correct, contact

your specialist dealer

>The loudspeakers have an impedance of 4 Ohms and can therefore

be connected to any standard amplifier - Contact your specialist dealer

concerning this

>Connect the PIEGA AP 3, AS 3 cables to your amplifier or receiver

as shown in the figure. Ideally, use the OPUS 3 loudspeaker cable

(optional) with banana plugs or standard loudspeaker cables with a lead

Active variant:

>For AP 3, AS 3 loudspeakers with the active module option, refer to the

separate user manual

Hinweis:

8 or 16 Ohm amplifiers supply at 4 Ohms twice or four times

the output, which considerably improves the output characteristics...!