beautypg.com

Introduction / general safety advice, Technical data, General safety advice – Parkside XQ600 User Manual

Page 5: Your working area, Electrical safety

background image

7

GB

1 Operating manual
1 Booklet “Warranty and Service”

Q

Technical data

Rated voltage:

230 V ~ 50 Hz

Rated power:

600 W

Nominal oscillations: n

0

5.000 - 16.000 min

-1

Nominal revolutions: n

0

2.500 - 8.000 min

-1

Excentricity:

5 mm

Sanding plate:

ø 150 mm

Protection class:

II /

Noise and vibration data:
Values determined in accordance with EN 60745
The sound pressure level (A-weighted) of the
device is typically 84 dB(A). Uncertainty K=3 dB.
The sound level while working can exceed 85 dB (A).

Wear ear protection!

Evaluated acceleration, typical:
Hand / arm vibration a

h

= 2,309 m / s

2

Uncertainty K = 1,5 m / s

2

WaRNING!

The vibration level given in these

instructions has been measured in accordance with a
standardised measurement procedure specified in
EN 60745 and can be used to compare devices.
Different uses of the device give rise to different vibra-
tion levels and in many cases they may exceed the
values given in these instructions. It is easy to underes-
timate the vibration load if the electrical power tool is
used regularly in particular circumstances.

Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particu-
lar period of working, you should also take into ac-
count the intervening periods of time when the de-
vice is switched off or is running but is not actually
in use. This can result in a much lower vibration
load over the whole of the period of working.

Kompernaß GmbH · 44867 Bochum

Germany · www.kompernass.de

XQ 600 KH 3168

230 V ~ 50 Hz · 600 W

2.500-8.000 min

-1

Schwingzahl: 5.000-16.000 min

-1

Date of manufacture: 02-2008

General safety advice

J

aTTENTIoN! Please read all the instructions
and advice. Failure to observe the instructions
and advice given below may result in electric
shock, fire and / or serious injury.

MAKE SURE THAT YOU KEEP THESE INSTRUC-
TIONS AND SAFETY ADVICE IN A SAFE PLACE.

1. Your working area

a)

Keep your working area clean and
clutter-free.
Untidy or poorly lit working
areas can lead to accidents.

b)

Do not work with the device
in potentially explosive en-
vironments in which there

are inflammable liquids, gases or
dusts
. Electrical power tools create sparks,
which can ignite dusts or fumes.

c)

Keep children and other people
away while you are operating
the electrical tool.
Distractions can

cause you to lose control of the device.

2. Electrical safety

a)

The mains plug on the device must match
the mains socket. The plug must not be
modified in any way. Do not use an
adapter plug with devices fitted with a
protective earth.
Unmodified plugs and
matching sockets reduce the risk of electric shock.

Introduction / General safety advice