beautypg.com

Gps 3500 specifications – Peavey GPS Series User Manual

Page 19

background image

19

GPS 3500 SPECIFICATIONS

Rated Power (2 x 2 ohms):

1750 watts @ 1 kHz both channels driven at <0.15% T.H.D.

Rated Power (2 x 4 ohms):

1200 watts @ 1 kHz both channels driven at <0.1% T.H.D.

Rated Power (2 x 8 ohms):

775 watts @ 1 kHz both channels driven at <0.1% T.H.D.

Rated Power (1 x 2 ohms):

1,850 watts @ 1 kHz at <0.1% T.H.D

Rated Power (1 x 4 ohms):

1,350 watts @ 1 kHz at <0.1% T.H.D

Rated Power (1 x 8 ohms):

850 watts @ 1 kHz at <0.05% T.H.D

Minimum Load Impedance:

2 ohms

Maximum RMS Voltage Swing:

89 volts

Frequency Response:

10 Hz - 100 kHz; +0, -.3d B at 1 watt

Power Bandwidth:

10 Hz - 40 kHz; +0, -3 dB at rated power

T.H.D. (2 x 2 ohms):

<0.15% @ 1400W from 20 Hz to 20 kHz with both channels driven

T.H.D. (2 x 4 ohms):

<0.1% @ 1050W from 20 Hz to 20 kHz with both channels driven

T.H.D. (2 x 8 ohms):

<0.08% @ 750W from 20 Hz to 20 kHz with both channels driven

Input CMRR:

> - 65 dB @ 1 kHz

Voltage Gain:

x 40 (32 dB)

Crosstalk:

> -75 dB @ 1 kHz at rated power @ 8 ohms

Hum and Noise:

> -115 dB, “A” weighted referenced to rated power @ 8 ohms

Power Consumption:

> 1400 watts

Slew Rate:

> 40V/us

Damping Factor (8 ohms):

> 325:1 @ 20 Hz - 1 kHz

SMPTE IMD:

<0.1% 60Hz and 7 kHz, 950W @ 4 ohms

Input Sensitivity (x 40):

1.7 volts for 4 ohm rated power, 1.4 volts for 2 ohm rated power

Input Impedance:

20 k ohms, balanced

Current Draw @ 1/8 rated
power @ 2 ohms:

11.66 A @ 120 volts

Cooling:

Two 80 mm DC fans, off until heatsinks reach 45

0

C, then temperature dependent variable speed

Controls:

Two front panel attenuators

Indicator LEDs:

Two DDT/Clip, 2 Signal, 2 Power

Protection:

Thermal, DC, turn-on bursts, subsonic, incorrect loads

Connectors:

XLR input, 6.3mm phone type output patch, Speakon and Binding Post speaker output, IEC mains input

Construction:

16 ga. steel reinforced with 12 ga.rack ears

Dimensions:

133 mm x 483 mm x 432 mm, 400 mm behind rear mounting ears (5.23" x 19" x 17", 15.75" behind rack ears)

Weight:

51.3 lbs. (23.3 kg)

Specifications subject to change without notice.