Rear panel front panel, Rear panel, Front panel – Pioneer CDJ-2000 User Manual
Page 10
DRB1474-A
En
10
q CUE/LOOP CALL/ (page 17), DELETE (page 17), MEMORY
(page
17)
r VINYL SPEED ADJUST RELEASE/START (page
18)
s JOG ADJUST (page
18)
t JOG MODE, VINYL mode indicator and CDJ mode indicator
(page
18)
The mode switches between VINYL and CDJ each time this is pressed. The
indicator for the selected mode lights.
u TEMPO ±6/±10/±16/WIDE (page
15)
v MASTER TEMPO (page
15)
w TEMPO (page
15)
x TEMPO RESET and TEMPO RESET indicator
Regardless of the position of the TEMPO dial, tracks are played at the
original playing speed recorded on the disc, etc. The indicator lights when
TEMPO RESET
is turned on.
y Jog dial (– REV/ + FWD) and JOG RING ILLUMINATION (page
18)
z Jog dial display section (page
11)
Rear Panel
A POWER ON OFF
Press to turn the power on and off.
B AUDIO OUT L/ R (page
12)
C AC IN (page
12)
D CONTROL (page
19)
E DIGITAL OUT
F Kensington security slot
G LINK (page
12)
H USB (page
12)
Front Panel
I Disc insertion slot
J Disc force eject pin insertion hole
K Disc insertion slot indicator
About ejecting discs by force
If the disc cannot be ejected by pressing [DISC EJECT], the disc can be
ejected forcibly by inserting the disc force eject pin all the way into the disc
force eject pin insertion hole on the main unit’s front panel.
When forcibly ejecting a disc, be sure to do so following the procedure below.
1 Press [POWER] and wait at least 1 minute after the set’s
power has turned off.
Never forcibly eject a disc directly after turning off the set’s power. Doing so is
dangerous for the reasons described below.
The disc will still be spinning when ejected and could hit your fingers, etc.,
causing injury.
Also, the disc clamp will rotate in an unstable way, and the disc could get
scratched.
2 Use the included disc force eject pin. (Do not use anything
else.)
The included disc force eject pin is mounted on the CDJ-2000’s bottom panel.
When the pin is inserted all the way into the insertion hole, the disc is ejected 5
mm to 10 mm out of the disc insertion slot. Grasp the disc with your fingers and
pull it out.