Polaroid DVP 300 - Manual (Page 12)

- 11 -
Connections
Connecting To an Amplifier With Dolby Digital or DTS Decoder
Connect the DVD Player’s DIGITAL AUDIO OUT jack (coaxial) to the
corresponding input jack on your amplifier with a digital (coaxial) audio cable
(not supplied).
When DVDs encoded in Dolby Digital or DTS are played, the Dolby Digital or
DTS bit stream is outputted from the player’s coaxial digital audio output.
When the DVD player is
connected to a Dolby Digital or DTS decoder, you
can enjoy theater quality audio in your home. A coaxial audio cable is
required for these connections, as shown below.
NOTE: If the amplifier has Dolby AC-3 decoding function, set the output format
of digital audio signal in setup menu to “SPDIF/RAW”.