Paxar Four Station Charger 6094 - Manual (Page 9)

2. Installing the Charger
The charger may be mounted to the wall or set on a sturdy
table. Before installing the charger
✓ set the power supply for the voltage in your area.
✓ select a location for wall mounting or table top use.
✓ perform the power on test.
Setting the Power Supply
When you first receive the charger, the power supply is factory
pre-set:
•
6094-01 is 120 VAC with 1A fuses.
•
6094-02 is 220/240 VAC with .5A fuses.
•
6094-03 is 100 VAC with 1A fuses.
To reset the power supply for 100, 120, 220, or 240 VAC:
1. Turn the power OFF.
2. Unplug the power cord.
3. Use the tip of a screwdriver or pen to open the fuse box as
shown. The fuse box is located on the left side of the
charger beside the power switch.
Fuse Box
3