Philips SBC RU 510 - Manual (Page 59)

To switch on teletext.
To enlarge the teletext display on screen.
To stop changing teletext pages.
To switch off teletext.
If you use the memory out key (fi) to access the next
teletext page on your Philips TV, see Troubleshooting.
Fasttext
Red
Green
Yellow
Blue
SET-UP FOR USE
A
D V I C E
Carefully read the complete procedure before starting!
Your TV is a Philips brand:
1
Press the power key to test.
– The green LED lights up to confirm transmission.
C
H E C K
Press a few keys to check correct response.
If response is not correct, go to the next paragraph.
Your TV is of another brand, or your TV is a
Philips brand, but not all keys respond
correctly:
1
Look up the brand name of the TV you want to operate in
the code list (centre of this manual).
2
Make sure the TV is switched on.
3
Press and hold keys 1 and 3 simultaneously - for about
three seconds- until the green LED lights up. (Release the
keys: the green LED should stay on)
4
Enter your 4-digit code using the number keys, within
30 seconds.
– The green LED flashes twice.
C
H E C K
That’s it! Press a few keys to check correct response. If
response is not correct, repeat procedure beginning at step 1,
using the next 4-digit code in the codelist.
N
O T E
- If the LED displays one long flash, the code was not
recognised. Please go back to step 1 and repeat the
procedure, using the next 4-digit code in the list.
- If no key is pressed within 30 seconds, you have to start
again at step 1.
- If no correct code is in the list, go to the next paragraph.
Instructions for use
3
English
9 - 0
1 3
SHIFT
SHIFT
SHIFT
SHIFT