4functional overview (fig. a), 5operation, 6technical specifications – Philips SCM4480/27 User Manual
Page 5: 7troubleshooting
5
ENGLISH
4
Functional overview (fig. A)
P
P H
H II L
L II P
P S
S
• Lights up when a 5V device is charging (when no
device is connected, the PHILIPS logo will flash).
• Flashes when the device is fully charged.
F
F o
olld
daab
blle
e p
po
ow
we
err p
pllu
ugg
Connects to the wall outlet.
U
U S
S B
B p
p o
o rrtt
Connects to 5V DC devices (mobile telephones,
MP3 players, etc.).
5
Operation
C
Ch
haarrggiin
ngg d
de
ev
viic
ce
ess -- p
prre
ep
paarraattiio
on
n
Check the maximum input voltage (V DC) of the
device you wish to connect. For this see the user
manual that came with the device.
Make sure the device does not consume more current
(mA) than 350 mA.
Check what connector tip is required for your device.
See the compatibility sheet for the proper tip for your
device.
C
Ch
haarrggiin
ngg 5
5V
V d
de
ev
viic
ce
ess (fig. B)
Insert the plug of the USB cable into the USB port (3).
Connect the connector tip to the USB cable.
Insert the connector tip into the power supply jack of
the device.
> P
P H
H II L
L II P
P S
S lights up when a device is charging.
> P
P H
H II L
L II P
P S
S will flash when the device is fully charged.
Disconnect the device from the USB charger.
Disconnect all cables from the device and from the
USB charger.
6
Technical specifications
• Rated input: 100V - 240V AC (50/60Hz), 0.2A
• Rated output: 5.4V, 350 mA
• Operating temperature: -10ºC - 40ºC
• Size: 70.3 x 55.5 x 35.5 mm (h x w x d)
• Weight: 70 g
• Maximum battery capacity for charging is 1,200mAh,
battery type is Li-Ion or Lithium Polymer
• Power consumption:
- in Off mode: 0 W;
- in Standby mode: 0.25 W.
7
Troubleshooting
P
Prro
ob
blle
em
m
– Possible cause
• Solution
U
US
SB
B cch
haarrgge
err d
do
oe
ess n
no
ott cch
haarrgge
e cco
on
nn
ne
ecctte
ed
d d
de
evviicce
e
– Voltage of device does not correspond with that of USB
charger.
• Refer to the user manual that came with the device.
– Improper connection between device and USB charger.
• Make sure that the USB cable is properly inserted into
the device and the USB charger.
– Damaged USB cable or connector tip.
• Replace USB cable and/or connector tip.
– Wrong connector tip used.
• Check connector tip and replace if necessary.
– Non supplied USB cable / connector tip used.
• Replace with supplied USB cable/connector tip.
– Problems with electrical circuit of USB charger.
• Take the USB charger to your local distributor.
5
5
4
4
3
3
2
2
1
1
3
3
2
2
1
1
3
2
1
SCM4480_27 05-03-2008 15:44 Pagina 5