Python 1090 User Manual

Page 36

b. The lights will flash as confirmation the remote start

command was received.

c. The system will send a remote start response to the remote

control.

d. A few seconds later the engine will start. For diesel vehicles

there may be a delay for the glow plugs to warm.

e. Once started, the engine will run for the programmed run

time and the lights will continue to flash or turn on.

“

remote

” The remote control Notification will be two beeps

ascending in tone followed by the remote start animation.

to drive the vehicle

a. Disarm the alarm and unlock the doors
b. Enter the vehicle but DO NOT step on the brake pedal.
c. Insert the key and turn the ignition to the run or on posi-

tion

d. Step on the brake pedal, the remote start will shut down and

the engine will continue to run. You are ready to drive.

to turn the engine off

While the remote start is active, the system will turn off if any of
the following occur:

a. Press and release the

button of the remote control two

times quickly.

b. Step on the brake
c. Open the hood