User id entry with csafe equipment – Precor Commercial Cycles C846i User Manual
Page 19

Product Owner’s Manual: Club Features
17
Displaying the Serial Number
SERIAL NUMBER appears on the display followed by the
13-digit serial number. The serial number is helpful when you
contact Customer Support.
Note: If no serial number has been entered, then NO SERIAL
NUMBER appears. Use the serial number found on a label on
the rear cover (Diagram 1).
11. If you have not already done so, write the serial number onto the
Warranty Registration card. You can also register online at
www.precor.com.
12. When you are ready, press ENTER to return to the Precor
banner.
User ID Entry with CSAFE Equipment
The C846i cycle is fully compatible with CSAFE protocols. When
the unit is connected to a CSAFE master device and the user
maintains a pedal speed above 20 revolutions per minute (RPM), the
user is prompted for a user ID.
Note: If the optional power adapter is being used, then no pedaling
is necessary for user ID entry.
The user ID is displayed as five zeros. The left most zero blinks
indicating you starting point. The following table describes key
functions while in CSAFE mode.
Keypad
Description
PROGRAM CHANGE
▲ or ▼ moves the blinking LED from
column to column
RESISTANCE
▼ or ▲
changes the number value in the in
the selected column
Number keypad
use the number keys to enter a user
ID. The number that is pressed
appears in the display and the next
column begins to blink. When all
five numbers are in place, the user
must press ENTER to submit the
user ID.
ENTER
submits the user ID.
Note: User ID entry is bypassed
when the user enter five zeros. No
workout statistics are recorded.
RESET
resets the display to the Precor
banner.