beautypg.com

Power supply – Philips DC1010 User Manual

Page 6

background image

CAUTION
- Visible and invisible laser radiation.
If the cover is open, do not look at
the beam.
- High voltage! Do not open.You run
the risk of getting an electric shock.
The machine does not contain any
user-serviceable parts.
- Modification of the product could
result in hazardous radiation of
EMC or other unsafe operation.
- Do not put the unit into cupboard
for use.

This set complies with the radio
interference requirements of the
European Community.

Power Supply

Whenever convenient, use the mains supply
cord if you want to conserve battery life.
Make sure you remove the plug from the set
and wall outlet before inserting batteries.

Batteries (not included)

1 Open the battery compartment and insert

six batteries, type R-14, UM-2 or C-cells,
(preferably alkaline) with the correct polarity
as indicated by the "+" and "" symbols inside
the compartment. (See 1)

2 Replace the compartment door, making sure

the batteries are firmly and correctly in place.
The set is now ready to operate.

– Remove battery if it is exhausted or
will not be used for a long time.

– Batteries contain chemical substances,
so they should be disposed of properly.

– Perchlorate Material-special handling
may apply. See www.dtsc.ca.gov/haz-
ardouswaste/perchlorate.

• Incorrect use of batteries can cause

electrolyte leakage and will corrode the
compartment or cause the batteries to burst:

• Do not mix battery types: e.g. alkaline with

carbon zinc. Only use batteries of the same
type for the set.

• When inserting new batteries, do not try to

mix old batteries with the new ones.

• Remove the batteries if the set is not to be

used for a long time.

Using AC Mains

1 Check if the power/mains voltage, as shown

on the type plate located on the
bottom of the set,
corresponds to your
local power supply. If it does not, consult your
dealer or service center.

2 Connect the power cord to the AC MAINS

inlet and the wall socket.The mains lead is
now connected and ready for use.

3 To switch the set off completely, withdraw the

power cord from the wall socket.

4

Install the unit near the AC outlet and where
the AC power plug can be easily reached.

Disconnect the mains lead from the wall
socket to protect your set during heavy
thunderstorms. Children could seriously injure
themselves as the free end of the cable may
still be live if only the connector is removed
from the MAINS socket at the back of the
unit.

The type plate is located on the bottom
of the set.

Helpful hints:

To avoid unnecessary energy consumption,
always adjust the source selector to OFF
after using the set.

Power Supply

IFU_12_DC1010_eng 2008.7.24 4:12 PM Page 6