beautypg.com

Warning, Troubleshooting – Philips DC1010 User Manual

Page 11

background image

Problem

Possible cause
• Remedy

No sound /power

Volume not adjusted
• Adjust the VOLUME
Power cord not securely connected
• Connect the AC power cord properly
Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
CD contains non-audio files
• Press

5 , 6 once or more to skip to a CD audio

track, instead of the data file.

Display does not function properly/ No
reaction to operation of any of the con-
trols

Electrostatic discharge
• Switch off and unplug the set. Reconnect after a

few seconds

Severe radio hum or noise

– Electrical interference: set too close to TV, VCR or

computer

• Increase the distance

- - indication

No CD inserted
• Insert a CD
CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
Laser lens steamed up
• Wait until lens has cleared
CD-R(W) is blank or not finalized
• Use a finalized CD-R(W) or suitable CD Audio

disc only

Note:

Make sure the CD is not encoded with
Copyright protection technologies, as some
do not conform to the Compact
Disc standard
.

The CD skips tracks

CD damaged or dirty
• Replace or clean CD
Program is active
• Quit program mode

Note:

A CD badly scratch or dirty may result in
improper operation
.

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.

WARNING:

Do not open the set as there is a risk of electric shock. Under no cir-
cumstances should you try to repair the set yourself, as this will
invalidate the guarantee.

Troubleshooting

IFU_12_DC1010_eng 2008.7.24 4:12 PM Page 11