beautypg.com

Clean and white mode brushing instructions, Brushing modes, Clean mode – Philips 700 Series User Manual

Page 7

background image

Place the toothbrush bristles against the teeth at a slight angle

towards the gumline.

3

Press the on/off button to switch on the Sonicare.

4

Apply light pressure to maximise Sonicare’s effectiveness and let the

Sonicare toothbrush do the brushing for you.

Gently move the brush head slowly across the teeth in a small back

and forth motion so the longer bristles reach between your teeth.

Continue this motion throughout the brushing cycle.

Note: To make sure you brush evenly throughout the mouth, divide your mouth

into 4 sections using the Quadpacer feature (see chapter ‘Features’).

Begin brushing in section 1 (outside upper teeth) and brush for 30

seconds before you move to section (inside upper teeth). Continue

brushing in section 3 (outside lower teeth) and brush for 30 seconds

before you move to section 4 (inside lower teeth).

7

After you have completed the brushing cycle, you can

spend additional time brushing the chewing surfaces of your teeth

and areas where staining occurs. You can also brush your tongue,

with the toothbrush switched on or off, as you prefer.

The Sonicare is safe to use on:

Braces (brush heads wear out sooner when used on braces)

Dental restorations (fillings, crowns, veneers)

Note: You can switch off the toothbrush at any time by pressing and holding

the on/off button for 2 seconds.
Clean and White mode brushing instructions

The Clean and White mode consists of 2 minutes of Clean mode to clean

the whole mouth and an additional 30 seconds of White mode to focus on

the visible front teeth.

1

Brush the first 2 minutes as instructed in steps 1-6 above.

After the minutes of Clean mode, the White mode begins with

a change in brushing sound and motion. That is your signal to start

brushing the visible upper front teeth for 1 seconds

3

At the next beep and pause, move to the visible lower front teeth

for the final 15 seconds of brushing.

Brushing modes
The Sonicare automatically starts in the default Clean mode. To select a

different brushing mode:

1

Press the on/off button to toggle between modes.

The green LED indicates the selected mode.

Note: You can only switch between modes when the toothbrush is switched on.
Clean mode

Standard mode for superior teeth cleaning.

-

-

,

1

2

4

3

1

2

4

3

EnglisH

7