Parkside PLS 30 - Manual (Page 13)

14 GB/IE/CY
Operation
Q
Operation
The mains voltage must correspond with that shown on the sander rat-
ing plate. Equipment labelled as 230 V may also be used with 220 V.
Q
Switching on and off
Switching on:
j
Insert the mains plug into a suitable mains socket.
Switching off:
j
Pull the plug out of the mains socket to switch off the device.
Q
Third hand
CAUTION! DANgER OF BURNS! The clips 5 on the
third hand 6 can become hot while you are soldering the
workpiece.
1. Fold out the third hand 6 upwards.
2. Rotate the clips 5 until they are oriented in the required direction.
3. Clamp the workpiece between the two clips 5 .
Q
Solder sponge
CAUTION! The hot soldering tip 2 must never be placed in
contact with a dry solder sponge 8 , otherwise the solder sponge
may be damaged.
j
The solder sponge 8 is used to clean soldering tips.
j
Moisten the solder sponge 8 before you use it.
33381_Content_LB6.indd 14 08.06.09 13:08