Philips 14PT1347 - Manual (Page 7)

7
To select connected equipment
Press to select EXT (1) and, on models with 2 euroconnector
sockets: EXT2 and Y/C2 ( S-VHS signal on EXT2 ).
The switch is automatic on most appliances (decoders, etc.).
Depending on the model, s o c kets are on the fro n t
(sometimes under a flap) or on the right-hand side of the set.
Headphones
When the earphones are plugged in, the sound on the set is
cut off. Adjust the volume using the
a keys.
The headphones must have an impedance of between 32 and
600 ohms.
Camcorder
Certain models are equipped with
AUDIO/VIDEO
connections. Make the connections, then use the key to
select EXT (or EXT2 for models with 2 euroconnector
sockets).The switch between the front and rear sockets is
automatic with priority on front sockets.
Front panel connections
Video recorder (only)
Connect as shown using a good quality euroconnector
cable.
If your video recorder does not have a euroconnector socket, the
only connection possible is via the aerial cable.You will therefore
need to tune in your video recorder test signal and assign it
programme number 0 (see manual store, p. 4).To reproduce the
video recorder picture, press
.
Video recorder with decoder
Connect the decoder to the second euroconnector on the
video re c o rd e r.You can then re c o rd scrambled transmissions.
Satellite receiver, decoder, DVD, games, etc.
For sets equipped with two euroconnector sockets, it is
best to connect the equipment which produces RGB signals
(digital decoder, DVD drives, games, etc.) to EXT1 and the
equipment which produces S-VHS signals (S-VHS and Hi-8
video recorders) to
EXT2 .
Video recorder
Connecting other appliances
Depending on the model, the TV is equipped with 1 or 2 euroconnector sockets, EXT1 and EXT2 .
The EXT1 socket controls audio video input/output and RGB input.
The EXT2 socket (if available) controls audio video input/output and S-VHS input.
Other equipment