Philips HD7826 - Manual (Page 16)

7 Empty the water reservoir to remove the last vinegar or mixture of
descaler and water.
8 Rinse the machine at least times by repeating steps 1 to 5, now
using fresh water.
Do not refill the water reservoir with used hot water.
Discard hot water each time.
9 Discard the used coffee pod and clean the pod holder after descaling
to prevent the sieve in the center from getting clogged.
This coffee machine has no other user-serviceable parts. Any other service
should be performed by the Philips Norelco Service location.
Storage
If the coffee machine has already been used and therefore has been
flushed with water, it may only be used and stored in a frost-free place to
prevent it from becoming damaged. Empty water resorvoir before storing
Assistance
For assistance, call toll free: 1-866-473-6736 or visit our website:
www. senseo.com
Information is available 24 hours a day, 7 days a week.
Troubleshooting
If you have a problem, you may find the solution in the table below. If
the table does not provide the solution to your problem or if you have a
question, see chapter ‘Assistance’.
Problem Solution
The indicator light continues
to blink slowly.
You have not yet flushed the coffee machine (see chapter ‘Preparing the
machine for use’).
You have used the SENSEO
\
coffee machine at an altitude higher than
6800 Ft. / 2200 m above sea level. This has caused the water in the
machine to start boiling before it has reached the required temperature,
which prevents the machine from functioning properly. Switch the
machine off and no longer use it at altitudes higher than 6800 Ft. / 2200 m
above sea level.
The SENSEO
\
coffee
machine does not produce
coffee when used for the
first time.
You have not yet flushed the coffee machine. When you use the machine
for the first time, you have to flush it before you start brewing coffee
(see chapter ‘Preparing the machine for use’).
The indicator light continues
to blink rapidly.
Make sure that:
the water reservoir has been properly placed;
,
,
16