PYLE Audio 747 - Manual (Page 14)

14
PIVOTING GUIDE SHOE FEATURES
1. Model 745 is supplied with a standard hex key guide shoe.
2. Models 746 and 747 are supplied with a keyless Quik-Change ™
guide shoe.
ADJUSTING PIVOTING GUIDE SHOE
DISCONNECT TOOL FROM POWER SOURCE.
DO NOT OPERATE THE TIGER SAW ® WITH THE GUIDE
SHOE REMOVED.
The pivoting guide shoe (A) Fig. 12, serves as a rest while making a cut and
it can be adjusted to accommodate many types of cutting applications.
1. The Model 745 pivoting guide shoe is adjusted by loosening the two
hex screws (with wrench supplied) located on the bottom of the front gear
housing (A) Fig. 12A. Loosen both screws enough to allow the pivoting
guide shoe to move freely. Adjust to desired position and securely tighten
both screws.
NOTE: Do not adjust the pivoting guide shoe out so far that it loses contact
with the back screw. Doing so will cause the guide shoe to be unstable.
After adjusting, make sure both screws are securely fastened.
Fig. 12
A
Fig. 12A
A