Philips CRA01/00 - Manual (Page 3)

D. Loop-Through Card I/O Interfaces
32-pin connector
6
5
4
3
2
1
Connector Application
1 15-pin D-SUB Female VGA Out (Local)
2 15-pin D-SUB Female (High Rise) VGA In
3 15-pin D-SUB Female (High Rise) VGA Out (External)
4 9-pin D-SUB Male RS232 Out (External)
5 9-pin D-SUB Male RS232 In
6 9-pin D-SUB Female RS232 Out (Local)
E. Installation Instructions
1. Turn off the power to your Philips monitor and disconnect the power cable.
2. Place monitor face-down on a clean, non-abrasive surface.
3. Locate the SmartCard slot opening on the rear of the display. (see Fig. 2 below)
SmartCard Slot Cap
Page 3 of 9 LT Installation Guide 1.1 (140907)
12NC: 3139 125 39281