Poulan Pro PP400E - Manual (Page 15)

15
Use only the Low Kickback replacement
chain specified in the list of available re-
placement parts. The chain must com-
ply with kickback requirements of ANSI
B175.1 when tested with this saw. See
your authorized service dealer to re-
place and sharpen individual cutters on
your chain.
TO REPLACE CHAIN:
1. Disconnect the chain saw from the
power source.
2. Remove bar clamp nuts.
3. Remove bar clamp and old chain.
Bar Clamp
Nuts
Adjusting Screw Bar
Clamp
4. Turn the adjusting screw counter-
clockwise to move the adjusting pin
almost as far as it will go to the rear.
Do not remove the adjusting screw
from the bar clamp.
5. Carefully remove the new chain from
the package. Hold chain with cutters
facing as shown.
CUTTERS MUST FACE IN
DIRECTION OF ROTATION
Tip of
Bar
Cutters Depth Gauge
Drive Links
6. Place chain around the sprocket and
fit the drive links into the guide bar
groove and then into the teeth of the
sprocket in the tip of the guide bar.
7. Hold the guide bar against the saw
frame and install the bar clamp. Be
sure adjusting pin is in the adjusting
pin hole in the bar.
Inside view of
Bar Clamp
Adjusting
screw
Adjusting pin
Adjusting pin hole
8. Secure the guide bar and bar clamp
with the bar clamp nuts; tighten
finger tight only.
CAUTION: If saw chain is installed back-
wards, the saw will vibrate excessively
and will not cut wood.
CHAIN ADJUSTMENT
See CHECK CHAIN TENSION in the MAIN-
TENANCE section.
CUSTOMER SERVICEABLE PARTS
WARNING: Use of any other ac-
cessory or attachment might present a
risk of injury to the operator.
REPLACEMENT PART PART NO.
Hex Nuts 530015917
Oil Cap 530053072
Bar Adjusting Screw 530016265
Bar Adjusting Pin 530053068
File (5/32″ dia.) Twin Pak 952055085
Xtra GUARDr Chain --18″ 952051338
Lo--Kickr Guide Bar -- 18″ 952044418
Bar & Chain Lubricant --1 qt. 952030203
Bar & Chain Lubricant --1 gal. 952030204