Pioneer BDP-LX08 - Manual (Page 17)

17
En
02
Connecting an AV receiver
or amplifier
Connect to an AV receiver or amplifier in order to enjoy the surround
sound of Dolby TrueHD, Dolby Digital Plus, Dolby Digital, DTS-HD
Master Audio, DTS-HD High Resolution Audio or DTS Digital
Surround. For instructions on connecting the TV and speakers to the
AV receiver or amplifier, refer to the operating instructions of AV
receiver or amplifier.
Note
• Make the settings in the Setup Navigator menu according to the
type of cable connected (page 20).
• To output video signals from this player, connect using one of
the following (not including when connected using an HDMI
cable): a component video cable (commercially available), an S-
Video cable (commercially available) or a video cable (included).
Connecting using a commercially
available HDMI cable
Caution
• When DTS-HD Master Audio and DTS-HD High Resolution
Audio signals are output as linear PCM signals, the DTS Digital
Surround signals are converted to linear PCM for output
(page 50).
R
R
AUDIO OUT ( 2 ch ) AUDIO OUT ( 7.1 ch )
VIDEO OUT
HDMI OUT
DIGITAL OUT CONTROL IN
L L
Y
PB
PR
FRONT
OPTICAL COMPONENT VIDEO
SURROUND CENTER
VIDEO
S-VIDEO
SUB WOOFER
SURROUND BACK
AC IN
HDMI OUT
P B
P R
COMPONENT S VIDEO
Player’s rear panel
To HDMI input terminal
From HDMI output terminal
AV receiver or amplifier
HD
MI
c
a
bl
e
(c
omme
rcia
lly
av
ailable)
To HDMI input terminal
TV
HD
MI
c
a
b
le
(c
omm
e
rc
ially
a
vailable
)
Match the direction of
the plug to the terminal
and insert straight.
Direction of
signal flow
LX08_WV_EN.book 17 ページ ２００８年７月１５日 火曜日 午後２時５１分