Pioneer S-HTD330 - Manual (Page 78)

Additional information 12
78
En
• Connect the COAX IN (LINE 2) jack on
the rear panel to the coaxial digital output
of an external playback component.
These include digital components such as an
MD player, digital satellite, or a game system.
Connect using a coaxial digital cable (not
supplied).
Reducing the TV and line signal
levels
• Default setting: ATT 6dB
Some sources may produce a high signal
level which may produce unpleasant
distortion from the speakers. In such cases,
you may need to reduce the signal level of the
auxiliary source (connected to the
TV or LINE
1 analog inputs) by switching on the
attenuator.
1 Switch the system into standby.
2 Press SYSTEM SETUP (SHIFT + HOME
MENU).
3 Use the / (cursor left/right)
buttons to select ‘TV ATT ?’ or ‘LINE1
ATT?’, then press ENTER.
4 Use the / (cursor up/down)
buttons to select ‘ATT OFF’, ‘ATT 6dB’ or
‘ATT 10dB’.
If the ATT 6dB setting still results in distorted
sound, try the ATT 10dB setting.
5 Press ENTER to confirm.
Recording mode
The Recording mode allows you to make
analog recordings from the
LINE 1 (OUT)
jacks.
When Recording mode is on, most sound-
related functions (including
SURROUND ,
ADVANCED , AUTO , SYSTEM SETUP )
become inactive. The display will briefly blink
RecMode On if you try and use a prohibited
function while Recording mode is on.
When Recording mode is off, the audio from
the analog output may be interrupted,
depending on the operation.
1 Press SOUND MODE.
2 Use the Use the / (cursor left/
right) buttons to select ‘Rec Mode?’.
3 Press ENTER.
4 Use the / (cursor up/down)
buttons to select ‘R.Mode On’ or ‘R.Mode
Off’.
CO
AXIAL IN
LINE 2
XV-HDT330_new.book 78 ページ ２００３年１月１６日 木曜日 午後４時１２分