Parkside EXCENTERSLIBER XQ270 - Manual (Page 10)

11 GB/IE
© Commissioning
© Switching on and off
Note! Always switch the rotary sander on before
applying it to the material to be worked, then make
contact with it.
When operating the device you can select be-
tween intermittent or continuous operation mode
To switch on intermittent operation mode:
˽
Press the ON / OFF switch 1 .
To switch off intermittent operation mode:
˽
Release the ON / OFF switch 1 .
Switching on continuous operation:
˽
Press the ON / OFF switch 1 , keep it pressed
down and press the locking button 2 .
Switching off after sustained operation:
˽
Press the ON / OFF switch 1 and then release it.
© Working instructions
½
Wait until the electric tool has stopped moving
before you put it down.
© Grinding Surfaces
˽
Turn the electric tool on, place the entire grinding
surface on the substrate that is to be worked
on and move it with moderate pressure across
the workpiece (see Illustration B, C, D).
Note: The rate of metal removal and the
grinding pattern are essentially determined by
the grinding disc that has been selected and
the grinding pressure. Only grind-ing discs that
are in perfect condition will provide good
grinding performance.
˽
Please ensure that the grinding pressure is
even. An excessive increase in the grinding
pressure leads not only to a higher rate of met-
al removal, but also greater wear and tear on
the grinding disc.
˽
You should not use a grinding disc that has
been used for working metal for other materials.
© Maintenance and Cleaning
WARNING! RISK OF INJURY! Before
carrying out work on the appliance, always remove
the plug from the power socket.
The rotary sander is maintenance free.
˽
Clean the appliance regularly, preferably direct-
ly on completion of the task.
˽
Use a dry cloth to clean the device. Under no
circumstances should you use petrol, solvent or
cleaners which attack plastic.
˽
Keep the ventilation openings clear at all times.
˽
Remove dust clinging to the sander
with a brush.
© Service centre
½
WARNING!
Have your device re-
paired only by qualified specialist
personnel using original manufacturer
parts only. This will ensure that your device
remains safe to use.
½
WARNING!
If the plug or mains
lead needs to be replaced, always have
the replacement carried out by the
manufacturer or its service centre. This
will ensure that your device remains safe to use.
© Warranty
This appliance is guaranteed for 3 years
from the date of purchase. It has been care-
fully produced and meti-culously checked
before delivery. Please keep your receipt
as proof of purchase. Contact your service
centre by telephone in case of questions
pertaining to the warranty. Your goods
can be transmitted free of cost only in this
manner. This warranty applies only to the
initial purchaser and is non-transferable.
Commissioning / Working … / Maintenance …/ Service centre / Warranty