Lexmark IBM 9077 - Manual (Page 135)

Configuration of IP-Forwarding Media Cards 117
The following message is returned along with the changed prompt:
Current port card is 3
GR 3> .
• To leave any maint prompt and return to the shell, enter quit .
Following are just a few maint commands we have found useful; of course,
your experiences may vary.
To see the list of maint commands for the receive side, enter maint 1 ; to see
the list of maint commands for the transmit side, enter maint 101 .
The maint 3 command gives you useful options for looking at a variety of
active interfaces. To look at media information per port, use maint 4 and the
port number, 0 or 1. Use maint 4 0 to see the information for the card’s port
0.
To display switch statistics, use maint 5 , which will give you information about
the number of packets to and from the switch (in the GRF).
You can return information about VPI/VCIs on a per port, per side basis with
maint 13 0 or maint 13 1, respectively. For information about traffic statistics
use maint 14 0 or maint 14 1 , respectively.