Lindy GMBH - Manual (Page 4)

1 . L C D M o n i t o r I n s t a l l a t i o n
1-1 Installation:
(1) The following process offers users the best way to set up your LCD
Monitor into a whole PC system with correct and safe installation.
(2) Turn off the power switch of the PC and disconnect from the mains
input supply.
(3) Connect one end of 15-pin XGA Signal Cable to the signal input
port on the LCD Monitor and the other end to the signal output port
of PC
(4) Connect the DC 12V power output jack to the 12V DC input socket
of the LCD monitor. Connect the power cord to the adapter and the
other end into a suitable AC power outlet socket.
(5) Now connect the PC power cord to the AC power outlet socket.
(6) Check all the connections are correct, then, Turn on the LCD
monitor power switch..
(7) A signal of “NO SIGNAL” will show on the upper corner of the
LCD panel. As shown in figure 1.
(8) Turn on the PC’s power switch Run the PC for image adjustment.
Figure 1. Display without Signal Input
CAUTION:
Only use the AC adapter supplied by the manufacture . User of other adaptor may
cause malfunction or danger and invalidate warranty.
2