Lennox International Inc. R22 - Manual (Page 5)

4
Safety Precautions
Operating Instructions
Care and Maintenance
Troubleshooting Tips
2
4
10
7
3
9
8
6
5
12
11
1
Control
Signal Transmitter
• Transmits the signals to the Floor
standing Type air conditioner
Operation Display of the Remote
Control
Indoor Fan Speed Selection Button
• To select the desired fan speed in three
steps [Low, Med, High]
Cooling ON Button
Temperature Setting Buttons
Power ON/OFF Button
• Operation will start when this button is
pressed, and stop when the button is
pressed again.
Timer Set Button
• Each time the button is pressed, the
mode is changed in the following
process.
Timer set (1, 2, 3, 4, 5, 6, 7 hours)
If you select “0:00” the off Timer function
will be cancelled.
Auto Airflow Direction Control Button
• The vertical louvers swing left and right.
• The horizontal louvers can be set by
hand.
Heating Button (Heat Pump Model Only)
Auto Mode Operation Button
(Cooling Model Only)
Soft Dry Operation Button
Indoor Fan Operation Button (Cooling
Model Only)
Electric Heater ON/OFF Button (Option)
1
2
3
4
5
6
7
8
9
10
11
12
Name and Function-Remote Control
Handling the remote control
• Aim at the signal receptor on the Floor standing Type air conditioner when operating.
• The remote control signal can be received at a distance of up to about 7meters.
• Be sure that there are no obstructions between the remote control and the signal receptor.
• Do not drop or throw the remote control.
• Do not place the remote control in a location exposed to direct sunlight, or next to a heating unit, or
other heat source.
Wireless Remote Control Puts all functions at your fingertips