Lucent Technologies AT&T 7400B - Manual (Page 82)

APPENDIX C: APPLICATION NOTES DEFINITY Communications System
7400B Data Module
Page C-2 User’s Guide
PROCOMM PLUS Procomm Plus is a data communications software package produced by
Configuring the Software
1 .
Datastorm Technologies, Inc. The following procedures are based on
version 1.1B of the software package.
Note: If Procomm Plus is being installed for the first time select
Hayes 2400 as the modem type.
To begin Procomm Plus, at the DOS prompt type
pcplus [ Enter ]
Press any key to display the Terminal Mode screen.
Press [ Alt ] [ s ] to display the SETUP FACILITY menu.
Select Modem Options.
Check that the options displayed on your screen match those in the
2 .
3.
4 .
5.
menu below. Change any options that do not match.
A –
B – ATDT
C – ˆM
D – ˜˜˜ + + + ˜˜˜ A T H 0 ˆ M
E –
PROCOMM PLUS SETUP UTILITY MODEM OPTIONS
Initialization command . . ATE1V1X4Q0&C1&D2 S7=255 s0=0ˆM
Dialing command . . . . . . . . .
Dialing command suffix . .
Hangup command . . . . . . . . . . ..
Auto answer command . . . . .
Wait for connection . . . . .
Pause between calls . . . . .
Auto baud detect . . . . . . . .
Drop DTR to hangup . . . . .
Send init if CD high . . . .
Alt-z: Help

Press the letter of the option to change:

Esc: Exit
˜˜˜ +++ ˜˜˜ ATS0=1ˆM
F – 45 seconds
G – 4 seconds
H – ON
I – YES
J – YES
6 . When you are finished, press [ Esc ] to return the SETUP
UTILITY menu.
7 . Select Result Messages.
8. Check that the options displayed on your screen match those in the
menu below. Add the messages for options D, E, and F.