Linn 500 Solo - Manual (Page 27)

19
This is the easiest bit. The blue light will flash for a few seconds when power
is first applied, then remain dimmed with the Klimax in standby mode. When
a signal is detected the light brightens up as the main power supply and
amplifier are enabled. If the amplifier needs to protect itself it will shut
down entirely for a few seconds and flash the light. There is no half way
current limiting; the amplifier can either do what is required of it or it will
shut down entirely. The amplifier will revert to standby 10 minutes after the
input signal is removed. To operate the Klimax, select a source on your preamp,
wait a couple of seconds for the Klimax to power up, then sit back and enjoy
it.
We wish you many happy years of listening pleasure.
From the Linn Klimax team.
5. Operation