Linksys PC22604 User Manual
Page 35
BRIDGING
If you select Bridging from the Advanced Management screen, the following
Bridging Parameters screen will appear.
1. To change the aging time, highlight Aging Time
Enter. The following prompt will ask you to enter a bridge aging period,
in seconds. Enter a new aging period and press the Enter key.
2. To change the
flood limit for all ports, highlight Flood Limit for All ports
following prompt will ask you to enter the flood limit, in packets per sec-
ond. Enter a a new flood limit and press the Enter key. Enter 0 for no
limit.
3. Press the Esc key until you return to the desired screen.
61
ProConnect II
®
Series
5. Type a packet count number from 1 to 999, or type 0 for an infinite pack-
et count. Press Enter.
6. Move to Size
will appear.
7. Type the packet size, from 0 to 1500, then press Enter.
8. Move to Timeout
appear.
9. Type a timeout value, from 0 to 999, and press Enter.
10. When you finish specifying the ping parameters, press Esc to start ping-
ing a remote IP address.
11. Press Esc again to return to the IP Networking screen.
60
Layer 2 Management 4-Port Gigabit Ethernet Switch