Life Fitness Fit-1 - Manual (Page 17)

STEP 24:
FIGURE 24
17
• Insert two GUIDE RODS (27) through the BOTTOM SHROUD BRACKET (20) and into the BASE (1) as shown on FIGURE 24.
• Slide two 3/4 X 2” WEIGHT STACK CUSHIONS (30) down over the GUIDE RODS (27) as shown in FIGURE 24.
• Using EXTREME CARE slide all twenty WEIGHT PLATES (31) down over the GUIDE RODS (27) on to the 3/4 X 2” WEIGHT
STACK CUSHIONS (30). Make sure that the WEIGHT PLATES (31) are all facing as shown.
• Slide the HEAD PLATE ASSY (29) down over the GUIDE RODS (27) onto the weight stack.
• Slide two 13/16” SHAFT COLLARS (50) over the GUIDE RODS (27) as shown in FIGURE 7.
• (NOTE: Lubricate GUIDE RODS (27) with silicon or teflon spray available at most hardware stores.)
• Apply WEIGHT STACK LABELS (58) to WEIGHT PLATES (31) and HEAD PLATE (29) as shown in FIGURE 24. Begin with first
number on at the HEAD PLATE (29) with larger numbers in consecutive order towards bottom of weight stack.
50
30
20
31
29
27
1
58